Facilities and Assets Covered

Terminal buildings and roof equipment

Included in the project-specific lightning, earthing and surge-protection review.

ATC towers and communication facilities

Included in the project-specific lightning, earthing and surge-protection review.

Radar and navigation aids

Included in the project-specific lightning, earthing and surge-protection review.

Aircraft hangars and MRO facilities

Included in the project-specific lightning, earthing and surge-protection review.

Fuel farms and hazardous areas

Included in the project-specific lightning, earthing and surge-protection review.

Runway lighting control buildings

Included in the project-specific lightning, earthing and surge-protection review.

Weather stations and communication towers

Included in the project-specific lightning, earthing and surge-protection review.

Why Protection Is Critical

Operational continuity and passenger safety

Requires dedicated engineering attention during risk assessment and detailed design.

Sensitive radar, navigation and communication electronics

Requires dedicated engineering attention during risk assessment and detailed design.

Hazardous fuel-handling areas

Requires dedicated engineering attention during risk assessment and detailed design.

Marine/coastal corrosion at some airports

Requires dedicated engineering attention during risk assessment and detailed design.

Authority-specific approval and interference constraints

Requires dedicated engineering attention during risk assessment and detailed design.

Sector Design Philosophy

The protection strategy should combine external lightning interception, down-conductor routing, earth termination, equipotential bonding and coordinated SPDs. The selected system must follow the current project specification, site conditions and authority requirements.

Engineering Design Workflow

1. Site Data

Collect drawings, dimensions, roof levels, coordinates, occupancy, critical equipment, hazardous classification and incoming services.

2. Risk Review

Evaluate strike exposure, local lightning activity, consequences of failure, fire risk, service continuity and project requirements.

3. System Selection

Select ESE or conventional IEC 62305 route only where accepted by the project specification.

4. External LPS

Define air termination, masts, down conductors, bonding and earth termination.

5. Internal Protection

Coordinate Type 1, Type 2 and signal-line SPDs with the electrical distribution and lightning protection zones.

6. Documentation

Prepare calculations, layouts, BOQ, technical specifications, method statement, test records and as-built drawings.

Typical BOQ

Item	Description	Quantity Basis
Air termination	ESE terminal or conventional rods/mesh as specified	Coverage and roof geometry
Mast/support	GI/SS mast, brackets, base or guying	Mechanical and wind-load design
Down conductor	Specified conductor, holders and test joints	Measured route and number of paths
Earthing	Electrodes, conductors, chambers and bonding	Soil study and earthing design
SPDs	Power and signal-line surge protection	Panel and circuit survey
Services	Installation, testing, commissioning and documentation	Complete project

Inspection, Maintenance and AMC

Visual Inspection

Check terminals, masts, conductors, joints, labels, supports, corrosion and mechanical damage.

Electrical Testing

Verify continuity, bonding, earth-system performance and SPD status using appropriate test methods.